Administrator KNX Introduction Series - Part 1 - Fundamentals, Advantages and Aesthetics 24 Apr 2026 Product Support This series of videos is intended as an introduction to KNX. If you work through the series you will have enough information about KNX to choose if it is right for your business or your project. The s... Learn
Administrator How do I enable KNX online catalogue in ETS 24 Apr 2026 Product Support Go to https://my.knx.org/shop/product?product_type_category=&product_type=online-knx-product-catalog Login to your account and purchase the license as if it was a product. You will not be charged for ... Learn
Administrator Creating an inscription on Gira's marking website 24 Apr 2026 Product Support With the Gira inscription service you can order the full range of Gira rocker covers, but with your own wording and symbols. This makes it a really great solution for easy control of your automation s... Learn
Administrator Which way should I mount a Kaiser dry lining back box? 24 Apr 2026 Product Support When using the Kaiser range of dry lining back boxes the tendency is to mount it with the wall fixing screws top and bottom and the keypad screws left and right. This is ok for most keypads however it... Learn
Administrator Which cable is suitable for extending temperature Probes? 24 Apr 2026 Product Support KNX cable, or a lighting flex (.5 or .75) Cat 5e/6 is not recommended as the cores can snap when terminating.... Learn
Administrator How do I interface Mitsubishi Ecodan with KNX 24 Apr 2026 Product Support To integrate the Mitsubishi Ecodan system it needs to come installed with its own Modbus RTU/ BACnet interface the MelcoBEMS Mini This has either a Modbus RTU or BACNet connnection that can be interfa... Learn
Administrator Why won't Gira Device Portal recognise S1 credentials? 24 Apr 2026 Product Support When registering an S1 in the Gira Device Portal, the S1 needs to be powered and able to access the Device Portal. You cannot pre register the device. If the S1 is powered and connected to the network... Learn
Administrator Fujitsu AC stopped communicating with KNX after a power outage when using an IntesisBox FJ-RC-KNX-1i? 24 Apr 2026 Product Support When a Fujitsu AC indoor unit is turned on, it scans its control line for any controllers or interfaces. As this scan is only performed on initial start up, it is imperative the IntesisBox FJ-RC-KNX-1... Learn
Administrator Intesis Panasonic PA-RC2-WMP comms problem in AUS/NZ 24 Apr 2026 Product Support Issue of non-communication between Panansonic AC units and Intesis PA-RC2-WMP-1 when installed with a Panasonic keypad on the same bus. Some Panasonic heatpumps in AU/NZ cannot support the power consu... Learn
Administrator Does a Collingwood constant current LED fitting work with KNX? 24 Apr 2026 Product Support Constant current light fittings from Colllingwood lighting are supplied with a specific type of constant current driver that doesn’t work with a standard KNX LED driver. However, it is possible to con... Learn
Administrator What are the different ways to connect to ETS via IP? 24 Apr 2026 Product Support The KNXnet/IP Tunnelling connection is a direct connection to a KNX line with no filter table. However a filter table may still be in operation at a higher level either in a twisted pair line coupler ... Learn
Administrator What is the device password for the Gira G1? 24 Apr 2026 Product Support After updating the firmware to V2.0.422 or higher, the Gira G1 is protected by a device password. The password can be found on a label on the Gira G1. If no password is noted here, the password is "de... Learn
